Data Sheet

DATASHEET - EMS2-XBR-Z-4
Three-phase current connector with plug, Pole 3, Devices 4, For use with
EMS2-D..., EMS2-D...-SWD..., EMS-R...
Part no. EMS2-XBR-Z-4
Catalog No. 197174
Alternate Catalog
No.
EMS2-XBR-Z-4

Delivery program
Product range   Electronic motor starter
Basic function   Accessories
Description   Three-phase current connector with plug
Pole   3
Devices  Number 4
For use with   EMS2-D...
EMS2-D...-SWD...
EMS-R...
Conductor cross-section 
mm
2
2.5
Technical data
General
Ambient temperature   -25 - +70
Design verification as per IEC/EN 61439
Technical data for design verification   
Rated operational current for specified heat dissipation I
n
A 25
Static heat dissipation, non-current-dependent P
vs
W 0
Heat dissipation capacity P
diss
W 0
Operating ambient temperature min.  °C -25
Operating ambient temperature max.  °C 70
IEC/EN 61439 design verification   
10.2 Strength of materials and parts   
10.2.2 Corrosion resistance   Meets the product standard's requirements.
10.2.3.1 Verification of thermal stability of enclosures   Meets the product standard's requirements.
10.2.3.2 Verification of resistance of insulating materials to normal heat   Meets the product standard's requirements.
10.2.3.3 Verification of resistance of insulating materials to abnormal heat
and fire due to internal electric effects
  Meets the product standard's requirements.
10.2.4 Resistance to ultra-violet (UV) radiation   Meets the product standard's requirements.
10.2.5 Lifting   Does not apply, since the entire switchgear needs to be evaluated.
10.2.6 Mechanical impact   Does not apply, since the entire switchgear needs to be evaluated.
10.2.7 Inscriptions   Meets the product standard's requirements.
10.3 Degree of protection of ASSEMBLIES   Does not apply, since the entire switchgear needs to be evaluated.
10.4 Clearances and creepage distances   Meets the product standard's requirements.
10.5 Protection against electric shock   Does not apply, since the entire switchgear needs to be evaluated.
10.6 Incorporation of switching devices and components   Does not apply, since the entire switchgear needs to be evaluated.
10.7 Internal electrical circuits and connections   Is the panel builder's responsibility.
10.8 Connections for external conductors   Is the panel builder's responsibility.
10.9 Insulation properties   
10.9.2 Power-frequency electric strength   Is the panel builder's responsibility.
10.9.3 Impulse withstand voltage   Is the panel builder's responsibility.
10.9.4 Testing of enclosures made of insulating material   Is the panel builder's responsibility.
10.10 Temperature rise   The panel builder is responsible for the temperature rise calculation. Eaton will
provide heat dissipation data for the devices.
10.11 Short-circuit rating   Is the panel builder's responsibility. The specifications for the switchgear must be
observed.
10.12 Electromagnetic compatibility   Is the panel builder's responsibility. The specifications for the switchgear must be
observed.
06/18/2021 Eaton Y7-197174 ED2021 V80.0 EN 1 / 2