Datasheet

EATON RF SYSTEM

Heating Actuator or Electrical Heater Panels CHAZ-01/01

Technical Specifications

Power supply 230-400VAC, 50Hz

Anschlüsse Steckkontakte

Leistungsaufnahme: 0.7W/230VAC, 1W/400VAC

Pre-protection Power circuit breaker 16A, charateristic C

Frequency 868,300MHz

Type of transmission Bi-directional, via coded telegrams

Indoor range Typically 30 - 50m, 2 walls + 1 ceiling

(depending on wall thickness and material !!)

Compatible with the following heater panel types:

Dimplex Unique and Dimplex Topaz, Dimplex

Classic, Siemens Unique, Siemens Classic,

in some cases Clima Extend

Degree of protection IP20

Degree of soiling 2

Operating temperature 0 to +45°C

Storage/transportation temp. -25 to +70°C

Colour of the enclosure similar to RAL9001

Dimensions of the enclosure HxWxD - 80 x 108 x 41 mm

Approval Printed onto the device

General information:

Operating mode red LED Heating green LED ECO

COMFORT: ON, only when heating is requested OFF

ECO: Night, frost, holiday, standby, window open ON, only when heating is requested ON, comfort extension possible

OFF: OFF Flashing (1x every 10s)

BACKUP*: ON, only when heating is requested OFF

* also possible without heating actuator, "Emergency mode" with a handwheel on the heating actuator and an internal sensor in the

electrical panel.

Whenever the heating is requested, both in “COMFORT” and in “ECO” mode, the red LED “HEATING” will be on.

When the “ECO” operating mode is active (green LED ECO is ON), it is possible to control the pre-set temperature on the “hand-

wheel” (green ECO-LED switches to OFF) by pushing the “Comfort extension" button (base setting 3 hours).

By pushing the “Comfort extension” button again you will get back to “ECO” (green LED ECO is ON).

Attention: The heating actuator for electrical panels expects a cyclical telegram at least once every hour.

Otherwise the device will automatically switch to "BACKUP" mode (= emergency mode).

Note: In order to ensure an optimal measurement of the room temperature, we recommend the use of a “heating actuator for E

panels“ in combination with a room controller. In this case, please follow the mounting instructios of the room controller.