Datasheet

EATON RF SYSTEM

Dimming Actuator CDAE-01/01, CDAE-01/02

Technical Specifications

Power supply 230VAC, 50Hz

All connections Single-wired 1.5mm² connections

Load CDAE-01/01

230VAC, 50Hz, 40-500W incandescent lamps or

electronic transformers, trailing-edge,

NO inductive LOADS!!!

Internal overload and short-circuit protection

CDAE-01/02

230VAC, 50Hz, 250W incandescent lamps or

electronic transformers, “dimmable“ energy-saving

lamps or LED lamps for reversed phase control

dimming

, trailing-edge,

NO inductive LOADS!!!

Internal overload and short-circuit protection

Pre-protection Power circuit breaker 16A, charateristic C

ATTENTION:

Keep at least 35 mm distance in case several devices are used. Do not place the

device near heat sources (transformers, halogen lamps etc.), keep a distance of

approx. 200 mm. Do not place dimm ing actuators on top of each other. Allow for

sufficient heat draw-off. Check max. operating temperature, reduce power where

necessary (see wiring diagram)

Frequency 868,300 MHz

Type of transmission Bi-directional, via coded telegrams

Indoor range Typically 30 - 50m, 2 walls + 1 ceiling

(depending on wall thickness and material !!)

Degree of protection IP20

Degree of soiling 2

Operating temperature -5 to +45°C

Storage /transportation temp. -25 to +70°C

Colour of the frame Grey, RAL7035

Size of the frame HxWxD - 150 x 34 x 28mm

Length of the connection wires 150mm

Approval Printed onto the device

As a general rule, only “dimmable“ energy-saving lamps or “dimmable” LED

lamps suitable for reversed phase control dimming can be dimmed. This is

explicitely stated on the packaging. The dimming result may to a large extent

depend on the type of lamps or LEDs used, or on the manufacturer. An insufficient

dimming result in connection with energy-saving lamps is not a reason for com-

plaint about the CDAE-01/02 dimming actuator, it will not be accepted as such and

is therefore excluded from every type of warranty.