RFN NS200 User’s Guide Document Number CUG NS200 Revision 1 Eaton’s Cooper Power Systems 910 Clopper Road, Suite 201S Gaithersburg, MD 20878 USA www.eaton.
Contents 1 About the RFN NS200 ............................................................................................................................ 3 2 Regulatory Notices................................................................................................................................. 4 2.1 Regulatory Notices - English ............................................................................................................. 4 2.2 Regulatory Notices - French .........................
1 About the RFN NS200 The RFN NS200 is a radio frequency communications device designed for use in Eaton radio communications products. The RFN NS200 provides a 915 MHz radio interface to an RF mesh network. The RFN NS200 operates from a power source of 5 VDC, received from the host device. The supplied voltage is regulated by the on-board power supply circuit. The radio modules operate in license-free bands at 915 MHz (902.75 to 927.25 MHz).
2 Regulatory Notices 2.1 Regulatory Notices - English Notice The Original Equipment Manufacturer (OEM) must ensure that FCC and Industry Canada Labeling requirements are met. This includes a clearly visible label on the outside of the OEM enclosure specifying the Eaton FCC identifier (FCC ID: P9X-NS200) and IC Number (IC: 6766A-NS200) as well as the FCC Notice below. This device complies with FCC Rules Part 15 and with Industry Canada license-exempt RSS standard(s).
Notice To comply with FCC and Industry Canada RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operate in conjunction with any other antenna or transmitter.” As such, the radio component of this device is intended only for OEM integrators under the following two conditions: The antenna must be installed such that 20 cm is maintained between the antenna and users.
Transmitters with Detachable Antennas Notice This device has been designed to operate with the antennas listed below, and having a maximum gain of 5 dB. Antennas not included in this list or having a gain greater than 5 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. Antennas that may be used with this product include: Linx ¼ Wave Through-hole Helical, 2.
Notification Notification Notification CUG NS200, Revision 1 Cet équipement a été testé et s'est avéré conforme aux limites pour un appareil numérique de classe B, conformément à la partie 15 des règles de la FCC. Ces limites sont conçues pour fournir une protection raisonnable contre les interférences nuisibles dans une installation résidentielle.
Notification Étiquetage du produit final Ce module émetteur est autorisé uniquement pour une utilisation dans les appareils où l'antenne peut être installée de telle sorte qu’une distance de 20 cm peut être maintenue entre l'antenne et les utilisateurs (par exemple des points d'accès, routeurs, modems ASDL sans fil, certaines configurations d'ordinateurs portables et autres équipements similaires).
3 RFN NS200 Specifications Radio Specifications Operating frequency 902.75 – 927.25 MHz Reliable data transmission Error detection, correction and retransmission RF output power 30 dBm (maximum) to -20 dBm Data rate 9.6 kb/s, 19.2 kb/s, 38.4 kb/s, 76.8 kb/s, 153.6 kb/s Receiver sensitivity -114 dBm (@ 1.0% PER, 9.
Eaton’s Cooper Power Systems 910 Clopper Raod, Suite 201S Gaithersburg, MD 20878 USA www.eaton.
