User's Manual

6/10/02
Eka Systems Proprietary 6/18
STEP 3 Install the BlueMeter Module
The BlueMeter add-on card must always be installed as the innermost option
board (the board closest to the kV meter’s main board). Please refer to the
GEkV meter’s option board installation procedure to install the BlueMeter
add-on card. If there are any other option boards, install them above the
BlueMeter add-on card.
STEP 4 Additional connections
To access the hub from MeterMate through serial port, connect a null-
modem serial cable between the COM2 port on the hub and any COM port
on the PC. Please note that the serial port on the hub is configured to
communicate at 9600 baud.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.