User's Manual

Gateway Hardware
10156-07 6 - 11 EkaNet Hardware Manual
Eka Proprietary and Confidential
7. Connect the input power wires (line marked L, neutral marked N, and
ground marked ) to the appropriate power input terminals in the
gateway.
8. Install the gateway at its predetermined location.
6.6 Verifying Gateway Connectivity
A crossover ethernet cable was supplied with your EkaNet Field Tool.
To use this cable to verify that the gateway is reachable:
1. Remove your ethernet cable from the gateway.
2. Plug in one end of the crossover cable into the ethernet connection on the
gateway.
3. Plug the other end of the crossover cable into the ethernet adapter on the
Field Tool.
Refer to the EkaNet Field Tool User Manual for instructions on troubleshooting
problems with the gateway using the Field Tool.
Figure 6.11 Power Input Terminals on an Outdoor Gateway
AC Power Connection
Terminals