User's Manual

Gateway Hardware
10156-07 6 - 9 EkaNet Hardware Manual
Eka Proprietary and Confidential
To install an outdoor gateway:
1. Open both latches on the side of the housing to reveal the gateway
hardware inside.
2. Remove the Compact Flash Card from the gateway. (See Figure 6.10)
3. Use the PDA (Field Tool Survey kit) provided to configure the gateway IP,
NTP server, and user parameters on the compact flash card. (See
“Configuring the Gateway Using the Field Tool” on page 6 - 1.)
4. Reinstall the Compact Flash Card in the gateway.
5. In order to attach the ethernet cable and the power cable to the gateway
you will first need to remove the knock out through which these cables will
access the electronics inside the housing. There are various knock out
locations on the housing. Use the one that best fits the environment in
which the gateway will be installed.
Figure 6.9 Weather-Proof Outdoor Gateway - Latches
Latches
Knock Out
Other
Knock
Outs
After the gateway is powered up, the compact flash card cannot be removed
for configuration.