User's Manual

Gateway Hardware
10156-07 6 - 5 EkaNet Hardware Manual
Eka Proprietary and Confidential
6.2.3 NTP Config Settings
6.3 The Compact Flash Card
The compact flash card on the gateway contains the EkaNet gateway software
and data collected from the nodes on the network. It may be necessary during
system operation to remove and replace the compact flash card with a new card
supplied by Eka.
To remove the flash card, press the release button next to the compact flash
card. The card will pop out and may be removed. To re-insert the card, slide it
securely back into the slot.
Once the compact flash card has been removed from the gateway it may be
inserted into the Field Tool. Refer to the EkaNet Field Tool User Manual for
instructions on troubleshooting problems with the gateway using the Field Tool.
Figure 6.4 Gateway Maintenance NTP Configuration
Select NTP Config as the Config Type to modify
NTP settings.
Complete the NTP Server using the valid name or
IP address of an NTP (Network Time Protocol)
server and tap Add.
Select Remove to remove highlighted server
name from the list of NTP servers.
Select Reload to reload the list of server names
stored on the compact flash card.
Power to the gateway must be turned off before removing and/or replacing the
compact flash card.