User's Manual

RESI-MON Node Hardware
10156-07 4 - 3 EkaNet Hardware Manual
Eka Proprietary and Confidential
4.1.2 RESI-MON Node Layout
Figure 4.2 below is a simple diagram of a RESI-MON node. The primary
components of the node are:
• the pulse interface connector - connects the node to the meter
• the DC power connection - supplies power to the node
• the node’s serial number - the node’s unique identifier
• LEDs - red and green lights displaying node’s operating status
Each RESI-MON node is uniquely identified with a serial number. This number
is displayed on the label and is contained on the bar code. In addition, the
number is also embedded in the node’s software. This serial number is the
number displayed on the Field Tool and Network Manager to identify the node.
Figure 4.2 RESI-MON Node Layout
FCC ID: P9X-900X
Eka Systems Inc.
Pulse +
LED Status Lights
Bar Code and label
contain the node’s
radio address and
serial number .
These numbers are
also embedded in
the node’s software .
Mounting Holes
+5V DC
GND
Pulse -
Mounting Holes
During installation, it is important to note the Eka Serial Number and the serial
number of the meter in which it is installed in order to map billing data from the
Eka serial number to the meter serial number at the database.