User's Manual
Table Of Contents
- EkaNet™ Hardware Manual
- Table of Contents
- List of Figures
- 1. Introduction
- 2. ECR-2400 Node Hardware
- 3. Elster A3/Alpha Plus Node Hardware
- 4. RESI-MON Node Hardware
- 5. EkaNet Pulse Node Hardware
- 6. Gateway Hardware
Elster A3/Alpha Plus Node Hardware
EkaNet Hardware Manual 3 - 1 10156-07
Eka Proprietary and Confidential
3. Elster A3/Alpha Plus Node Hardware
FCC Notice
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Warning
The Original Equipment Manufacturer (OEM) must ensure that FCC Labeling requirements are
met. This includes a clearly visible label on the outside of the OEM enclosure specifying the
appropriate EKA Systems FCC identifier for this product as well as the FCC Notice below.
Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning
The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population;
consult Safety Code 6, obtainable from Health Canada's website www.hc-sc.gc.ca/rpb
.