User's Manual

ECR-2400 Node Hardware
10156-07 2 - 4 EkaNet Hardware Manual
Eka Proprietary and Confidential
2.1.2 ECR-2400 Node Layout
Figure 2.2 below is a simple diagram of an ECR-2400 node. The primary
components of the node are:
• the meter interface connector - connects the node to the meter
• the AC power connection - supplies power to the node
• the node’s serial number - the node’s unique identifier
• LEDs - red and green lights displaying node’s operating status
Each ECR-2400 node is uniquely identified with a serial number. This number is
displayed on the label and is contained on the bar code. In addition, the number
is also embedded in the node’s software. This serial number is the number
displayed on the Field Tool and Network Manager to identify the node.
Figure 2.2 ECR-2400 Node Layout
AC Power
Connector
Meter Interface
Connector
Bar Code and label
contain the node’s
radio address and
serial number.
These numbers are
also embedded in
the node’s software.
LED Status Lights
Antenna
00140800001C
1400000018
FCC ID P9X2400b
During installation, it is important to note the Eka Serial Number and the serial
number of the meter in which it is installed in the event that the node and/or
meter require troubleshooting.