User's Manual

ECR-2400 Node Hardware
10156-07 2 - 2 EkaNet Hardware Manual
Eka Proprietary and Confidential
Warning
To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operate in conjunction with any other antenna or transmitter.”
As such, the radio component of this device is intended only for OEM integrators under the
following two conditions:
1. The antenna must be installed such that 20 cm is maintained between the antenna and
users
2. The transmitter module may not be co-located with any other transmitter or antenna.
As long as the two conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end product for any additional
compliance requirements required with this module installed (e.g., digital device emissions, PC
peripheral requirements).
In the event that these conditions cannot be met (for example, co-location with another
transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot
be used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for example
access points, routers, wireless ASDL modems, certain laptop configurations, and similar
equipment). The final end product must be labeled in a visible area with the following:
“FCC ID: F9X2400B”.
The radio component is an integral part of the Eka module and cannot be removed.