Network Card User Manual

OPERATION AND MAINTENANCE
EATON Power Xpert
®
Gateway Series 1000 Card User’s Guide S 164201670 Rev 1
72
Table 12. Stacked Indicator Descriptions
Label Color Illuminated Not Illuminated
STATUS Green Communication with the PDU has been
established.
Communication with the PDU has not
been established. As the card boots, the
indicator remains off. However, if it
remains off after one minute, there is a
communication problem between the
card and the PDU.
DHCP Amber At least one port is configured for DHCP
and has obtained IP address information.
The use of DHCP/BOOTP has been
disabled by the user, or all ports
configured for DHCP have failed to obtain
IP address information.
IDENT Red A firmware update is in progress. Do not
remove the card from the PDU.
A firmware update is not in progress.
POWER Green DC power is available to the card from
the PDU.
If all indicators are not illuminated, DC
power is not available from the PDU. This
may indicate that the PDU is off and
unplugged.
NOTE
During the power-on sequence, all four indicators are illuminated for approximately 20 seconds. Wait at least
one minute for the card’s boot process to complete before comparing the indicators to the table above because
indicators may turn on and off at different times in the boot process.