Network Card User Manual

GETTING STARTED

EATON Power Xpert

Gateway Series 1000 Card User’s Guide S 164201670 Rev 1

9. Type 2 and press Enter on the Network Settings menu (see

Figure 10 on page 11) to display the Network Settings: Ethernet

Port 2 menu (see Figure 14).

----------------------------------------------------------

------ Network Settings: Ethernet Port 2 ------

----------------------------------------------------------

1. Dynamic Addressing (DHCP) Enabled

2. IP Address [None]

3. Subnet Mask [None]

4. Default Gateway [None]

MAC Address 00:60:26:10:89:A8

Link Status Enabled

0. Exit to previous menu

Select an option ==>

Figure 14. Ethernet Port 2 Menu

10. Repeat Steps 2 through 7 t o assign the IP address and other

options for Port 2.

11. If you will be using host names for controlling access to the card,

type 3 and press Enter. Type the primary DNS server IP address and

press Enter.

Type 4 and press Enter. Type the secondary DNS server IP address

and press Enter (see Figure 15).

---------------------------------------------------------

---------------- Network Settings ----------------

---------------------------------------------------------

1. Ethernet Port 1 Settings

2. Ethernet Port 2 Settings

3. DNS Server (Primary) : 10.222.51.8

4. DNS Server (Secondary) : [None]

5. Reset to Factory Defaults and Exit

6. Save & apply all settings

0. Exit without saving

Select an option ==> 4

Figure 15. DNS Server Settings