Network Card User Manual

GETTING STARTED

EATON Power Xpert

Gateway Series 1000 Card User’s Guide S 164201670 Rev 1

6. Verify that the PDU is turned on.

7. After a few seconds, press Enter. The Network Settings menu

appears in approximately one minute (see Figure 7).

---------------------------------------------------------

---------------- Network Settings ----------------

---------------------------------------------------------

1. Ethernet Port 1 Settings

2. Ethernet Port 2 Settings

3. DNS Server (Primary) : [None]

4. DNS Server (Secondary) : [None]

5. Reset to Factory Defaults and Exit

0. Exit

Select an option ==> 1

Figure 7. Network Settings Menu

If the menu does not appear, press Enter again. If it still does not

appear, check the following conditions:

S Verify the serial line is set to 9600 baud, No parity, 8 data bits,

1 stop bit, and no flow control.

S If the serial line settings are correct, check the cabling to verify

all connections are secure.

S Verify that your terminal program is on the correct

communication port for the serial connection.

S Verify that the card has power (one or more LEDs on the card

are illuminated). The PDU should be on.

8. Continue to the following section, “IP Address Assignments.”