Installation Manual

FLEXTRAY
FLEXTRAY™ - Installation
D-54
B-Line series Cable Tray Systems Eaton
90° Horizontal Bends (Long Radius)
90° Horizontal Bend From (2) Straight Sections
• Make your own field cut horizontal sweeps using CLEANSHEAR
™
to make safe, smooth cuts
• Can be made from any tray width and depth with any available finish
• Cut as many segments as required to control sweep radius (use chart for recommendations)
• One (1) WASHER SPL KIT is required to connect each cut segment minus one, this segment
uses one (1) SPLICE BAR, two (2) FTHDWE 1/4 and two (2) BTM WASHER
Flextray Width Side Sections WASHER SPL KIT
in. (mm) To Be Removed Qty.
4” (100) 12
6”
(150) 22
8”
(200) 22
12”
(300) 32
16”
(400) 42
18”
(450) 52
20”
(500) 52
24”
(600) 62
30”
(750) 82
32”
(800) 82
• Cut required number of wire side sections listed in
chart per the illustration below
(Illustration is for a 8”
(200mm) width)
• 1.5” deep FLEXTRAY has only one (1) side wire
2” deep FLEXTRAY has two (2) side wires - shown
4” deep FLEXTRAY has three (3) side wires
6” deep FLEXTRAY has four (4) side wires
• Illustration shown below is for a 8” (200mm) width
• 1.5” deep FLEXTRAY has only one (1) side wire
2” deep FLEXTRAY has two (2) side wires - shown
4” deep FLEXTRAY has three (3) side wires
6” deep FLEXTRAY has four (4) side wires
Component Qty.
Flextray Segments FTHDWE 1/4
Width To Be WASHER & SPLICE
in. (mm) Removed SPL KIT BTM WASHER BAR
4” (100) 21 2 1
6”
(150) 32 2 1
8”
(200) 43 2 1
12”
(300) 65 2 1
16”
(400) 76 2 1
18”
(450) 87 2 1
20”
(500) 10 921
24”
(600) 11 10 21
30”
(750) 13 12 21
32”
(800) 13 12 21