Installation Manual

FLEXTRAY
FLEXTRAY™ - Installation
D-51
B-Line series Cable Tray SystemsEaton
X
Completely adaptable, the Flextray system is designed
to accommodate jobsite changes. Cut wires with our
Angular Bolt Cutter, bend to create a bend, tee, or
reducer.
For the best results, use a WB30BC angular blade offset
bolt cutter with 24"
(600 mm) long handles.
The offset blade cutter produces a clean cut. Position
bolt cutter blades near the cross wire and perpendicular
to wire to be cut (see illustration above). Proper cut
will make the assembly faster, easier and safer while
minimizing grinding.
Cut and remove each wire as illustrated below.
Follow cutting pattern and blade positioning. Placing
Flextray open side down provides the optimum
cutting angle.
Cutting Order
The Greenlee
®†
cable wire cutter makes flush cuts without
burrs. Will cut .191"
(4.8mm) diameter wire in 2 seconds.
Cutting head rotates 330° for ease of positioning and the
tool automatically retracts when cut is complete.
Comes with 2 batteries, charger, and carrying case.
Approximately 250 cuts per charge.
WB30RB
Replacement Blade
WB30BC
Angular Bolt Cutter
≠
Æ
Ø
∞
±
≤
≥
Offset Cut
Do not use center
cut blades.
Part Length Wt. Per Cutter Box
Number
in. (mm) lbs. (kg)
Quantity
WB50WC 12
3
/4” (324) 3.0 (1.3) 1
Part Number Description Box Quantity
WB50RB Replacement Blade 1
WB50BA Replacement Battery 1
Angular Bolt Cutter
Part Description Qty./Box Wt./Box
Number
lbs. (kg)
WB30BC Bolt Cutter 1 6.8
(3.1)
WB30RB Replacement Blade 1 1.3
(0.6)
†
Mark shown is the property of its respective owner.