Cut Sheet

Lay-In Wireway

Type 1 Screw Cover - Painted & Galvanized

Data Sheet

Construction

• Wireway body and cover are fabricated from code gauge steel

or galvanized steel, (see table, pages 9 & 10)

• Wireway body has mounting holes on the back

• Wireway is available with or without knockouts

• Wireway fittings have no knockouts, ends are available with or

without knockouts

• Cover is secured to the body with plated screws

• Keyhole slots are furnished on the wireway cover which allow

easy access to the inside without removing the screws

• Wireway exceeding 72 inches in length has two overlapping

covers

• Variety of fittings allow runs which can change direction,

junction and terminate

• Standard wireway connectors (sold separately) have a

gate feature which can swing completely open allowing for

lay-in of wire and cable

• Interchangeable with Type 1 Hinge Cover Wireway and

Fittings when HSCA connector is used, (see page 17)

Discount Schedule: A2

Subclass: AK1

(painted) & Z40 (galvanized)

Application

• Houses runs of control and power cable

• Used for cable and wire junction, distribution and

termination

Standards

• UL 870 listed, Type 1

• CSA C22.2 No. 26 certified, Type 1

• Conforms to NEMA standard for Type 1

Finish

• Wash and phosphate undercoat or galvanized steel

• ANSI 61 gray acrylic electrocoat finish

Accessories

• Sealing devices

• Touch-up paint

• See Accessories section

Notes: We can provide special sizes, finishes and other modifications. Consult the factory for your special requirements.

Cable & Wire Management

B-Line series electrical enclosuresEaton