Instruction manual

7
INSTALLATION
1. Connection of the Input Cables
Connect this welding & cutting equipment with power supply of 220V AC.
Connect the earth terminal with the earth cable of minimum diameter of
2.5mm
2
.
2. Connection of the Output Cables
2a. Install welding/cutting torch according to the drawing.
2b. Connect the one-knob connector and air plug to the corresponding
connector on the panel board. Then fasten the screw.
2c. Plug the air plug of the back cable to in the clockwise direction. Connect
Main Current
Pilot Lamp
Power Lamp
Compress Air Gas
Inlet
Argon Gas Inlet
Compress Air Gas
Regulator
Power Switch
Torch 2-pin Socket
Torch Connection
Function
Switch
Electrode
Holder
Connection
Ground
Connection
CT-312
Ground Connection
Main Current
Pilot Lamp Power Lamp
Power Switch
Compress Air Gas
Inlet
Argon Gas Inlet
Compress Air Gas
Regulator
Function
Switch
Torch 2-pin Socket
CT-213
Torch Connection