Specifications

7
If your machine comes with an air regulator/filter you will need to secure the bracket
to the machine and then fasten the regulator to the bracket. Locate the in and out
labeled on the regulator body. Cut a section of hose long enough to bend around the
back of the machine as pictured and secure it to the outlet on the regulator and the
inlet to the machine.
Next you will need to connect an air compressor to the inlet to the regulator. The air
compressor should be set to a higher pressure than the compressor requires.
Set the knob on the regulator to the specified pressure your machine requires.
After long duration of use, you will need to push the water release button to release
water from the water separator section of the regulator. It is designed to remove water
from the air.
Assembly of the Torch Consumables
EasyCut 40
The torch handle is made of bakelite which is fire and heat resistant.
Do not drop or strike anything with the torch.
The on/off switch can be positioned on the top, side or bottom of the torch body to
allow ease of use.
Ceramic Ring
Ceramic Cup
Copper Tip Double Side Electrode
Torch Head