Specifications

6
INSTALLATION
Connecting the Power Cord Plug
You will need to go to a hardware store to locate an electrical plug designed for
your outlet. The machine requires either 110v/220vac at a specified amperage
rating. Locate a plug rated at the correct voltage and amp rating your machine
requires. If you do not know how to connect the plug most stores have
representatives that can assist you in determining proper hookup. As a general rule
of thumb the green wire or green with yellow stripe is the ground wire.
Connecting the Cables to the Machine
Begin by locating the ground clamp and end connection. Place the connector into
the machines ground connection and turn it clockwise until it locks into position
(about 1/3 turn).
Connect the torch connector to the machine using a wrench or adjustable wrench.
Only tighten snug, do not over tighten nut. Plug in the trigger on/off connector and
hand tightens the retainer nut.
Connecting the Air Supply to the Machine
Power Cord Water release button
Pressure
adjust knob
Power Switch
Compress Air Inlet