Specifications

Introduction

The EasyCut series plasma cutter is a revolutionary new approach to plasma cutting

technology. Easyweld introduced a more efficient way to cut metal while keeping the

cost of operation lower. This was accomplished using several new approaches to

the mainstream technology. One of these methods is our proprietary plug-and-play

main circuit boards which allow ease of repair, reducing the downtime to only hours

rather than days, while also reducing repair costs averaging less than $15! The

cut4O uses special safety redundant circuitry with built in auto-protection and self

adjusting circuitry to keep your machine running in a safe threshold. This helps

protect your machine from over-voltage, power spikes, tip blowouts and shorting.

Warranty

The machine is insured against damage upon shipping. If you machine is damaged

in any way when you receive it, you must retain all shipping materials and packing.

Call our customer service department and report the damage immediately.

There is a 1 year warranty on all internal electronic parts. The torch, cables, power

cord, clamps, air regulator, hoses, case & paint and consumables are not covered

under warranty. You must use dry air via the air regulator and empty the reservoir

from the water separator frequently to insure proper protection from moisture.

This machine is designed to operate from 200~240VAC/380VAC at 50-60Hz Only.

Operating outside of limits will void warranty.

Warranty coverage covers repair or replacement of damaged machine or

damaged circuit board. Warranty does not cover shipping from the customer

but does cover return shipping within the Cont. United States. If you are going

to return a machine to us for repairs, it must be well packed and insured.

Customers who own machines that require warranty coverage should contact

our warranty department by email at info@hkweld.com to obtain a return

authorization code.

Customers who own an out-of-warranty machine that require repairs should