Instruction Manual

Easythreed X4 3D Printer

Install Manual

This manual is written in accordance

with EasyThreed X4 3D printer。

Printer upgrades and equipment models

are slightly different, is a normal phenomenon,

based on the actual products received.

User’s manual inside TF card.

PAGE 1
Easythreed X4 3D Printer Install Manual This manual is written in accordance with EasyThreed X4 3D printer。 Printer upgrades and equipment models are slightly different, is a normal phenomenon, based on the actual products received. User’s manual inside TF card.
PAGE 2
Parts List：Take out parts from package , check if all parts have as listed below。 ` 1. Install the XZ Axis set to the Printer Base. 2. Install it downward in the direction of this arrow 1.
PAGE 3
2.After insert the XZ Axis, Fixed with 2 screws. Fixed with screws 3. Connect the Z-axis motor line to the output line of the printer control box as shown in the figure below..
PAGE 4
.Install the Filament Holder as below. Important Notice：This filament holder can only hang on 250g weight filament. connect the power and start the 3D printing journey.。 ShenZhen EasyThreed Technology CO.,LTD http://www.easythreed.com info@easythreed.