X1 User Manual

3 , Power on
Insert our X1 provided power cable to power port at the side of the printer control box，electricity
connected successfully when the light inside button is on。(Precaution: the USB port is
preserved by our technical person for firmware updated , please do not use it ; If printing finished or
no need to use for quite a long time, take off the power cable to power off)
4，Slicer software application (STL format 3D file need be sliced to gcode
format that printer can recognize).
(1).This 3d printer runs with it’s own developed slicing software named Easyware , it is in the TF
card included in the accessories box , please copy it to your computer and no need
installation ,you can also download Easyware from official website, and you can watch Slicer
operation video in Youtube channel. Easyware slicer can recognize STL format 3D file.
(2). STL format 3D file need be sliced to .gcode format, and save to TF card, and Insert TF card to
printer, then can print 3D file. (3D Printer can recognize gcode format file only)
Warm Notice: there is a gcode file inside the TF card when it come from factory
5，Print
（ 1 ）Platform Leveling，The first time to use this printer, you need leveling the platform
Please adjust the distance between the nozzle and the platform in 1，2，3，4，points, the
distance should be just the thickness of a sheet of paper.( Please do this leveling with the help of
adults.)
a), Click the button , Z axis will go home position. After Z axis come to home position, please turn off
the power, after turn off the power ,then you can move the X axis and Y axis by hand
b),Move the nozzle to 1 point, And put a sheet of paper between the nozzle and the platform, if
the distance is too far , turn the hand-twisted nut counter-clockwise to make the printing
platform rise to the standard distance. If the distance between the nozzle and the platform is too
close, turn the hand-twisted nut clockwise to make the printing platform fall to the standard
distance, (check the distance is right or not .that is, when drawing A4 sheet, the nozzle should be
attached to the A4 sheet without scratching it).
c), do the same way to adjust another 1，2，3 ，three points。
d), When the distance between the nozzle and the platform all is right distance in 1,2,3,4,four
points, leveling finished and succeed.
Please turn on the power again after platform leveling