Owner`s manual

EasyStand Glider Assembly
FIG. 4
FIG. 1
FIG. 1- Attach the front caster frame to the front frame with
bolts and tighten securely. Laying your unit on the floor side
ways may help with lining up the holes.
FIG. 2- Attach the casters to the rear base frame. Tighten
securely using the provided wrench. Ensure the casters are
flush with the rear base frame. The casters are supplied with
a locking compound pre-applied to the threaded stem. Do not
remove this material, it is important to prevent the casters
from loosening over time.
FIG. 3- Place the front frame and the seat assembly on its
side, slide the front frame into the opening of the seat
assembly as shown. Line up holes and insert all four bolts
first, then place nuts onto bolts and tighten securely with hex
wrench and 19mm open-ended wrench. Place unit upright on
its wheels.
FIG. 4- Remove the ratchet handles and bolts from the glide
handles, slide the glide handles into the slots. Tighten
securely. If any additional options were ordered, please refer
to the drawings on pp. 5-10. Install the seat onto the seat
assembly after all other options are added.
Front Frame
Seat Assembly
®
®
Videos on EasyStand assembly & fitting can be viewed at easystand.com/videos
Page 3 - Assembly
FIG. 3
FIG. 2
Use FIG. 1 - FIG. 3 for International orders only.