Owner`s manual

Page 19 - Perfect Fit Guide

Perfect Fit Guide

step one - measure

Before transferring into the Glider, measure for

approximate (A) seat depth and seat to (B) foot plate

settings.

step two - seat depth

To adjust seat depth, loosen the knob under the

seat (C). Use measurement (A) and measure from

the inside of the knee pad to the back. Depress the

snap button on the adjustment tube while moving

the back (D). Adjust the seat depth until the proper

measurement has been reached. Tighten the knob

step three - back angle

After achieving the desired seat depth, rotate the

back angle (E) adjustment knob so the (F) seat/back

angle indicator on the side of the unit is in the green

area prior to standing.

Note: Repeat steps 2 and 3 for each color

adjustment.

step four - foot plates

Use the (B) measurement to adjust the foot plate

height. Loosen the (G) knobs on the foot plates to

adjust height. Tighten the knobs after positioning.

The knees should be slightly lower than the hip (H).

step ﬁve - positioning

Position the user’s hips as close as possible to (I)

Glider’s hip pivot.

step six - knee pad

Slide into knee pads (J) and secure the calf straps

behind the knees.

(C)

(D)

(B)

(A)

(F) (E)

Caution: These adjustments are only to be made

while the unit is unoccupied and in the seated

position.

(G) (H)

(I) (J)

Inspect your standing frame periodically to ensure it is in safe operating condition.