Owner`s manual

Charging the Battery

The EasyStand Pow’r Up Lift uses two 12 volt sealed lead batteries rated at 2.9 amps each. An

EasyStand can be lifted approximately 100 times on one full battery charge. An audible alarm will

sound when the battery is low. Please charge the battery after the alarm sounds. A battery needing

to be fully recharged will take approximately 8 hours. The EasyStand

can be raised to the standing position while being charged. The

function of the charger is to detect a full battery and then provide a

constant potential power supply to hold the battery at a full

condition without overcharging. When the battery EMF rises to a

factory preset point, the charger circuit will not allow the peak

output voltage to exceed that value. This factory setting protects

a battery from excessive depletion of electrolyte, which can occur

from overcharging. The charger can be found in the tool pouch on

the back of the unit.

CAUTION: Use only the Linak charger, model numbers 00CH01-XX

OR 10CH01S-00, provided by Altimate Medical with the Pow’r Up

option.

1. Plug the receptacle into a wall outlet. The light on the charger will

be green indicating an open circuit.

2. FIG. 9- Plug the charger cord into the side of the hand control.

The light on the charger will turn yellow indicating the batteries are

being charged.

3. FIG. 10- The unit will arrive unplugged from the battery, plug in

the white cord that supplies power to the actuator and the black

cord that supplies power to the remote. The black cord has a notch

on it to orient the connector properly. Fully charge battery before

use.

Note: The white cord has a rubber washer on it, which makes it

very sticky and sometimes will not get pushed in completely, make

sure to push the cord all the way into the battery.

4. When the batteries are charged, the light on the charger will turn green.

5. Fully charge the batteries every three months or less during periods of intermittent or non-use.

CAUTION: Ensure the cables are attached properly per the instructions for use. Do not allow the

cables to drag on the ﬂoor or to catch on objects.

FIG. 9

FIG. 10

Pow’r Up Lift Option

The hand pendant

is a Type BF applied

part.

Page 11 - Pow’r Up Lift Option