Owner`s manual

page 6
EasyStand Evolv Assembly
FIG. 5
FIG. 4
Evolv E3
Spacer
If you ordered the Swing-Away Front, please refer to pp. 7-8
If you ordered the Independent Kneepads refer to p. 25
FIG. 4- Remove ratchet handle and hardware from the knee
bracket. Place the bracket and hardware onto the column in
the order shown. Ensure the spacer is placed in between the
two steel brackets. Place the washer and bracket bolt into the
bracket assembly and tighten snug, ensuring the knee b
racket
moves freely. Do NOT overtighten bolt. Place the washer and
ratchet handle into the bracket assembly. Tighten ratchet han-
dle once desired position is reached.
Remove the three bolts from the kneepad making sure the
plastic insert stays in place. Place the kneepad onto the
bracket and insert top two bolts before inserting the middle
bolt. Tighten securely. If you ordered the independent
kneepads, p
lace pads into knee bracket, make sure the larger
end of the pad is on the outside of the unit (see drawing on
p. 25).
If you ordered the Shadow Tray, please refer to pp. 9-10.
FIG. 5- Insert the tray post into the front column with the
holes in the post facing upward. The tray clamp on the front
frame may need to be adjusted to fit the tray post into the
frame. Place tray onto the tray post, insert nut i
nto slot and
bolt into hole, tighten securely.
If you ordered any additional options, please refer to the draw-
ings on pp. 18-26.
FIG. 6- Install the seat onto the seat assembly after all the
other options are added. For easier installation, pump the seat
halfway up. Start all four bolts first, then tighten
securely.
For Evolv adjustments, see pp. 27-30.