Owner`s manual

EasyStand Evolv Assembly
FIG. 2A
FIG. 3A
page 4
For Mobile assembly refer to p. 11
For Glider assembly refer to p. 13
If you ordered the Evolv XT, your unit will be fully assembled ex-
cept for the tray and back option. Refer to p. 18 for the back op-
tion assembly, p. 23 for the tray assembly and p. 9 for the
Shadow Tray. For any other option assembly, please refer to
pp. 18-26.
FIG. 1- Attach the front caster frame to the front frame with
bolts a
nd tighten securely.
FIG. 2A- Attach the casters to the rear base frame. Tighten se-
curely using the provided wrench. Ensure the casters are flush
with the rear base frame. The casters are supplied with a lock-
ing compound pre-applied to the threaded stem. Do not re-
move this material, it is important to prevent the casters from
loosening over time.
FIG. 2B- Place the front frame and the seat assem
bly on it’s
side, slide the front frame into the opening of the seat
assembly as shown. Line up holes and insert all four bolts
first, then place nuts onto bolts and tighten securely with hex
wrench and 19mm open-ended wrench. Place unit upright on
its wheels.
If you ordered the Swing-Away Front option, slide the front
frame into the opening of the seat assembly as shown on p. 7.
To help with installation, p
lace folded cardboard or a block of
wood underneath the frame for support. Start all four bolts
first, then tighten securely.
For more Swing-Away Front assembly, refer to p. 7.
Lift seat up and flip foot plates down. Then insert ratchet
handles (located in bag with owner’s manual, E3 model will
have ratchet handle already attached) into foot plates. Tighten
securely.
FIG. 3A- Attach the pump handle to the pump on the seat as-
sembly with bolts and nuts, tighten securely.
FIG. 3B- Insert top of handle into pump handle and tighten
bolts securely.