Owner`s manual

Perfect Fit Guide
page 35
(C)
(D)
(B)
(A)
(F) (E)
Perfect Fit Guide
(I) (J)
(G) (H)
(K) (L)
Before transferring into the stander, measure for ap-
proximate (A) seat depth and seat to (B) foot plate
settings.
step one - measure
step two - seat depth
step three - back angle
After achieving your desired seat depth, rotate the back
angle (E) adjustment knob so the (F) seat/back angle in-
dicator is in the green area prior to standing.
Note: Repeat steps 2 and 3 for each color adjustment.
Use the above measurement (A) to adjust the seat
depth on the stander. To adjust seat depth, loosen the
knob under the seat (C). Depress the snap button on
the adjustment tube while moving the back (D). Tighten
the knob after adjusting.
For the Evolv: Use measurement “A” and measure
from the front of the seat to the back. Adjust the seat
depth until the proper measurement has been reached.
For the Glider: Use measurement “A” and measure
from the center of the kneepad to the back. Adjust the
seat depth until the proper measurement has been
reached.
s
tep four - foot plates
Use the (B) measurement to adjust the foot plate
height. Loosen the (G) ratchet handles on the foot
plates to adjust height and plantar/dorsi. Tighten
ratchet handles after positioning. The knees should
be slightly lower than the hip (H).
step five - position
ing
If you have a Glider, skip to step six.
Position the user’s hips as close as possible to (I)
stander’s hip pivot. To determine correct positioning,
only two fingers should fit between the front of the
seat and the back of the knee (J).
step six - kneepad
For the Evolv: Adjust the (K) kneepad so it fits
comfortably up to the knees.
For the Glider: Slide into kneepads (L) and secure
the calf straps beh
ind t
he knees.
Caution: These adjustments are only to be made
while the unit is in the seated position.
!