Owner`s manual

page 29
Adjusting Your Evolv
FIG. L
FIG. M
Seat Depth/Back Angle
Caution: These adjustments are only to be made
while the unit is in the seated position.
FIG. L- Loosen the knob on the seat tube located
under the seat. Do not
unscrew seat depth knob
all the way when adjusting the seat.
Depress the spring button and position the back
so that the hip pivot is located as close as
possible to the user’s hips. Tighten the seat depth
knob securely.
Note: Adjust back angle after each seat depth po-
sition change.
FIG. M- To adjust the back angle, use the knob lo-
cated on the following arm. Before standing, the
back angle must be set
so the indicator on the
side of the unit is in the green.
FIG. N- The back/seat angle locator is located on
the side of the unit. When the unit is in the seated
position, the green area indicates the back angle.
Before standing, the indicator must be in the
green.
Caution: Before standing, the seat/back angle in-
dicator must be in the green. Failure to set the
back angle in green prior to standing could cause
the unit to lock in a standing position, causing
damage to your unit.
!
FIG. N
FIG. O
Tray/Front Pad
FIG. O- To adjust the height of the tray/front pad,
loosen the clamp located just above the front
column. Lift the tray to the user’s desired height
level and tighten the clamp.
To adjust the depth of the tray/front pad, loosen
the clamp located just below the tray. Move the
front pad to the user’s desired position and
tighten the clamp.
Caution: While lowering the tray height, keep
hands clear of the area underneath the tray.
!
!
Green Area