Owner`s manual

page 15
Pow’r Up Lift Option
Charging the Battery
The EasyStand Evolv Pow'r Up Lift uses two 12 volt sealed lead
batteries rated at 2.9 amps each. An EasyStand Evolv can be
lifted approximately 100 times on one full battery charge. An
audible alarm will sound when the battery is low. A battery
needing to be fully recharged will take approximately 8 hours.
The EasyStand Evolv can be raised to the standing position
w
hile being charged. The function of the charger is to detect a
full battery and then provide a constant potential power supply
to hold the battery at a full condition without overcharging.
When the battery EMF rises to a factory preset point, the
charger circuit will not allow the peak output voltage to exceed
that value. This factory setting protects a battery from exces-
sive depletion of electrolyte, w
hich can occur from
overcharging. The charger can be found in the tool pouch on
the back of the unit.
CAUTION: Use only the Linak charger, model numbers
00CH01-XX OR 10CH01S-00, provided by Altimate Medical
with your Pow'r Up option.
1. Plug the receptacle into a wall outlet. The light on the
charger will be green indicating an open circuit.
2. FIG. A- Plug the charger cord into the side of the hand
co
ntrol. The light on the charger will turn yellow indicating the
batteries are being charged.
3. FIG. B-The unit will arrive to you unplugged from the battery,
you need to plug in the white cord that supplies power to the
actuator and the black cord that supplies power to the remote.
The black cord has a notch on it to orient the connector
properly. Fully charge battery before use.
Note: The white cord has a rubber washer on it, which makes it
very sticky and sometimes will not get pushed in completely,
make sure to push the cord all the way into the battery.
4. When the batteries are charged, the light on the charger will
turn green.
See notes under Safety Precautions on p. 2 for additional
battery information.
FIG. A
FIG. B
!
Pow’r Up Lift Option