Owner`s manual

ManualsBrandsEasyStand ManualsHome GymGlider

page 12

Mobile Assembly

FIG. 18- Place the front frame onto the wheel frame. Line up

the two bolts with the holes on the wheel frame, start both

bolts before tightening securely.

FIG. 19- Attach the casters to the rear base frame. Tighten se-

curely using the provided wrench. Ensure the casters are flush

with the rear base frame. The casters are supplied with a lock-

ing compound pre-applied to the threaded stem. Do not re-

move t

his material, it is important to prevent the casters from

loosening over time.

FIG. 20- Place the front frame and the seat assembly on its

side, slide the front frame into the opening of the seat

assembly as shown. Line up holes and insert all four bolts

first, then place nuts onto bolts and tighten securely with hex

wrench and 19mm open-ended wrench. Place unit upright.

FIG. 21-Place the left-side mobile a

ssembly onto the wheel

frame. Line up holes and insert top bolt through the inside as

shown. Place the nut onto the bolt and hand tighten. Line up

holes and insert bottom bolt through the outside as shown.

Hand tighten the nut onto the bolt, then tighten both bolts se-

curely with a 19mm wrench and hex wrench. Repeat on the

opposite side before continuing to the next step.

FIG. 22- Place mobile bra

cket onto the kneepad bracket. Place

kneepad onto the mobile bracket. Insert three bolts into the

back of the kneepad. Tighten bolts securely. Remove bolts

from mobile bracket. Flip down kneepad and align bracket on

mobile assembly. Tighten bolts and nuts securely with 13mm

wrench and hex wrench. Repeat steps on the opposite side

before continuing to the next step.

Lift seat up and flip foot plates down. Then insert ratchet

handles into foot plates. Tighten securely.

FIG. 23- Your Mobile is equipped with wheel locks for safety

while transferring and stability while performing stationary

activities. Note the directional arrows imprinted in the center

hub of each handrim.

To assemble the tray and seat, go to p. 6, FIG. 5.

Wheel

Locks

Front Frame

Wheel Frame

FIG. 18

FIG. 21

FIG. 22

FIG. 23