Owner`s manual

FIG. 16
page 10
Shadow Tray Assembly
FIG. 15
FIG. 15- To install the support arm, first remove the nut from
the bolt that is pre-assembled to the arm, leaving the bolt and
the two halves of the fitting (one plastic and one metal) in
place on the tube. Thread the bolt into the hip plate, as shown
in Fig. 16. Once the bolt has been secured and the support
arm has the desired level of tension, install the nut on the bolt
protruding through the opposite s
ide of the hip plate, closest
to the user. Use either the small end of the wrench from the
supplied tool kit, or a 17mm socket wrench (preferred) to se-
curely tighten the nut, see p. 30. A setscrew in the metal half
of the support arm fitting may be used to adjust the level of
the tray once the installation is complete.
FIG. 16- Install the tray arm rest to the unit with the two bolts
attached. Tighten
bolts securely.
FIG. 17- Place chest pad onto tray tubes. Place tray onto
bracket and insert the bolts into the bracket and tighten
securely.
For Shadow Tray adjustments, see p. 30.
FIG. 16
FIG. 17