Owner`s manual

page 9
Shadow Tray Assembly
Shadow Tray Assembly
Shadow Tray Bracket Set-up
®
FIG. 10- On the support arm, remove the plastic
bag with two mounting bolts and a silver pin.
Using a hex wrench, remove the end cap from
the Shadow Tray arm.
End Cap
FIG. 11- Release the plunger by pulling it down, twist
to keep it released.
FIG. 12- Insert the silver pin into the support arm as shown,
while supporting the silver pin, place the support arm into
the Shadow Tray bracket until it clicks into place.
Silver Pin
Shadow Tray Bracket
Support Arm
FIG. 13- The knobs on the end of the support arm should
be exposed. Rotate the arm down to 90˚. Lock the plunger
into place.
Knobs
FIG. 14- Use a rubber mallet to tap the black cap into the
Shadow Tray bracket. Replace the end cap and tighten se-
curely.
These assembly instructions are
shown for the right side mounted
Shadow Tray, for the left side
mounted Shadow Tray, installation will
be on the opposite side.