Owner`s manual

FIG. 16

page 29 page 10

Shadow Tray Assembly

FIG. 15

FIG. 15- To install the support arm, ﬁrst remove the nut and

the washer from the pre-assembled bolt on the arm, leaving

the bolt and the two halves of the ﬁtting (one plastic and one

metal) in place on the tube. Thread the bolt into the hip plate,

as shown in Fig. 16. Once the bolt has been secured and the

support arm has the desired level of tension, install the nut

and lock washer on the bolt protruding through the opposite

side of the hip plate, closest to the user. Use either the small

end of the wrench from the supplied tool kit, or a 17mm

socket wrench (preferred) to securely tighten the nut, see

p. 30. A setscrew in the metal half of the support arm ﬁtting

may be used to adjust the level of the tray once the installa-

tion is complete.

FIG. 16- Install the tray arm rest to the unit with the two

bolts attached. Tighten bolts securely.

FIG. 17- Place chest pad onto tray tubes. Place tray onto

bracket and insert the bolts into the bracket and tighten

securely.

For Shadow Tray adjustments, see p. 30.

FIG. 16

FIG. 17