Owner`s manual

page 24
Adjusting Your Evolv
FIG. F
FIG. G
Seat Depth/Back Angle
FIG. F- Loosen the two clamp knobs located on
each of the seat tubes under the seat.
Do NOT unscrew seat depth knobs all the way
when adjusting the seat.
Depress the spring button and position the back
such that the hip pivot is located as close as
possible to the user’s hips.
Tighten the two clamp knobs.
Using the knob located on the following arm,
adjust the back angle to vertical +/- 10 degrees.
Caution: If the back is adjusted outside of
+/- 10 degrees from vertical, it is possible for
the back angle adjustment knob to come
into contact with the lower back tube,
causing damage to the unit.
Tray/Front Pad
FIG. G- To adjust the height of the front
pad, loosen the clamp located just above
the front column. Lift the tray to the user’s
desired height level and tighten the clamp.
To adjust the depth of the front pad, loosen
the clamp located just below the table.
Move the front pad to the user’s desired
position and tighten the clamp.
Adjusting Your EasyStand
®
Evolv
™
•
•
•
•
•
•
•