User Manual

4
It is your responsibility to:
• Regularlyinspectandmakenecessaryrepairstocompressorinordertomaintain
proper operation
• Makesurethatpressureisreleasedfromcompressorbeforestartingmaintenance
Checkintakeandexhaustfiltersafterfirst500hoursofoperation.Cleanfiltersanddeter-
minehowfrequentlyfiltersshouldbecheckedduringfutureoperation.Thisoneproce-
dure will help to assure the product’s performance and service life.
1 Disconnectelectricalpowersupplytounit
2 Vent all air lines
3 Removefiltercover
4 Checkfilterfelt.Replacefeltifitiscoveredwithcontaminationorshowssignsof
increasingdierentialpressure
5 Reinstallfeltandfiltercover
Check that all external accessories such as relief valves and gauges are attached to
cover and are not damaged before re-operating product.
SHUTDOWN PROCEDURES:
It is your responsibility to follow proper shutdown procedures to prevent compressor
damage. Never add oil to this oil-less compressor.
Proper shutdown procedures must be followed to prevent pump damage. Failure to do
so may result in premature pump failure. Compressors are constructed of ferrous metals
or aluminum which are subject to rust and corrosion when pumping considerable vapors
such as water. Follow the steps below to assure correct storage and shutdown between
operating periods.
1 Disconnectplumbing
2 Operatecompressorforatleast5minuteswithoutplumbing
3 Runatmaximumvacuumfor10to15minutes
4 Repeat step 2
5 Disconnectpowersupply
6 Plug open ports to prevent dirt or other contaminants from entering compressor
SRC25/SRC50 REPAIR KIT INSTALLATION:
WARNING!ElectricalShockHazard.Disconnectelectricalpowersupply
before installing repair kit. If product is hard wired into system, discon-
nect electrical power at the circuit breaker or fuse box before installing repair kit. Vent all
air lines to release pressure or vacuum. Failure to follow these instructions can result in
death,fire,orelectricalshock.
EasyPro will not guarantee eld-rebuilt compressor performance. For performance
guarantee, the compressor must be returned to EasyPro.
Repair kit contents may vary.
1 RemovescrewsfromtheheadofcompressorusingT25Torxdriver,removethehead.
2 Marktheorientationofheadplate(s)andremove.
3 Remove old cylinders and discard.
4 RemovescrewsfromcupretainerplatewithT15Torxdriver.Discardoldcupsand
retainer screws.
5 Setnewcylinder(s)onpiston(s).
(continuedonnextpage)