User Manual

2
INSTALLATION:
WARNING!ElectricalShockHazard.Disconnectelectricalpoweratthe
circuit breaker or fuse box before installing this product. Install this product
where it will not come into contact with water or other liquids. Install this product where it
will be weather protected. Electrically ground this product. Failure to follow these instruc-
tionscanresultindeath,fireorelectricalshock.
Correct installation is the responsibility of installer. Make sure of proper installation condi-
tionsandthatclearancesdonotblockairflow.
WARNING! Blockingairflowovertheproductinanywaycancauseproductto
overheat.
MOUNTING:
Compressor may be installed in any orientation. Mounting the product to a stable, rigid
operating surface and using shock mounts will reduce noise and vibration.
PLUMBING:
RemoveplugsfromtheINandOUTports.Connectwithpipeandfittingsthatarethe
same size or larger than threaded ports. Be sure to connect the intake and exhaust
plumbing to the correct inlet and outlet ports. Ports will not support plumbing.
ACCESSORIES:
Thecompressor’sexternalintakewillprovideadequatefiltrationinmostapplications.
Checkfiltersperiodicallyandreplacewhennecessary.Avoidexcessivelydustylocations.
Install relief valves and gauges at inlet, outlet or both, to monitor performance. Check
valvesmayberequiredtopreventbackflowthroughpump.
MOTOR CONTROL:
It is your responsibility to contact a qualied electrician and assure that the electri-
cal installation is adequate and in conformance with all national and local codes/
ordinances. The metal capacitor must be grounded.
The wiring diagram supplied with the compressor provides required electrical information.
Check that power source is correct to properly operate the dual-voltage motors.
ELECTRICAL:
WARNING! Electrical Shock Hazard. This product must be properly
grounded.Donotmodifytheplugprovided.Ifitwillnotfittheoutlet,have
theproperoutletinstalledbyaqualifiedelectrician.Ifrepairorreplacementofthecordor
plugisnecessary,donotconnectthegroundingwiretoeitherflatbladeterminal.Check
theconditionofthepowersupplywiring.Donotpermanentlyconnectthisproductto
wiring that is not in good condition or is inadequate for the requirements of this product.
Failuretofollowtheseinstructionscanresultindeath,fireorelectricalshock.
Model with a power supply cord: This product must
be grounded. For either 120 volt or 220/240 volt circuits
connect power supply cord grounding plug to a matching
groundedoutlet.Donotuseadapter.Seediagramatright.
In the event of an electrical short circuit, grounding re-
duces the risk of electric shock by providing an escape
wire for the electric current. This compressor may be
Grounded Plug
Grounding Pin
Grounded Outlet
120-volt grounded connectors
shown. 220/240-volt grounded
connectors will differ in shape.