Operation Manual

2
Safety Information
1. Do not disassemble the camera. Touching the product's
internal parts could result in injury. In the event of a
malfunction or if the camera is accidentally broken open,
take the product to an authorized service center for
inspection.
2. Avoid contact with liquid crystal. Should the LCD Screen
break, care should be taken to avoid injury due to broken
glass and to prevent the liquid crystal from touching the
skin or entering the eyes or mouth.
3. Do not use in the presence of flammable gas. Using
electronic equipment near flammable gas could result in
explosion or fire.
4. Observe proper precautions when handling batteries. The
camera uses only AA Alkaline, NiMH, or Lithium batteries.
Batteries may leak or explode if handled improperly.
Remove the batteries (and the memory card) from the
camera if you are going to store the camera for
extended periods. Ensure the camera is turned off before
inserting or removing batteries. Insert batteries correctly.
Do not expose batteries to flame or excessive heat. Do
not immerse batteries in or expose to water. Discontinue
use immediately if you notice any changes in the battery
such as discoloration, deformation, or leakage.
5. Observe caution when operating the flash. Do not use the
flash close to anyone's eyes. This can cause temporary
damage to eyesight. Particular care should be observed
when photographing infants - keep the flash at a
distance of at least 1 meter from infants' eyes.