Operating instructions

INSTALLING THE SOFTWARE
23
The setup program should start automatically. If this does not happen, pro-
ceed as follows:
- Open the easyScan 2 Installation CD.
- Start the program ‘StartCDMenu.exe’.
- Click ‘Full Installation of Nanosurf easyScan 2’.
The installation program will now start installing all components of the
Nanosurf easyScan 2 AFM: The hardware drivers, the easyScan 2 software,
DirectX 9.
- Follow the instructions given by the setup program.
Step 1 - Installation of hardware drivers
The Nanosurf hardware needs instrument drivers for the USB hub, the
USB interface and the AFM Video Module. These are installed first.
- Connect the USB cable to the easyScan 2 Controller.
The red USB power light on the Controller should now light up, and the
PC should now automatically detect that new devices have been connected
to it, and start installing the drivers. On some computers, the detection and
installation process may take some time (20 seconds or more), please be
patient. Once all the drivers listed below have been installed, click OK in
the Step 1 Dialog.
If you have already installed the easyScan 2 software or the Mobile S soft-
ware on this computer, it is possible that nothing will happen, because the
drivers are installed already. In this case the drivers listed below should be
displayed in the Windows device manager. If this is the case, you can also
click OK in the Step 1 Dialog.
Standard-USB-hub
The operating system should first find the ‘Standard-USB-hub’, and install
its driver. The installation order of the other drivers may vary.
High Speed Serial Converter
When the operating system finds the ‘USB <-> serial interface’, it asks what
to do: