Operating instructions

INSTALLING THE EASYSCAN 2 AFM
20
Installing the AFM Video Module
- Connect the Video Camera cable to the connector on the AFM Video
Camera (Components, 4) and the Video In connector on the Controller
(figure The easyScan 2 Controller (p.16)).
In case of an upgrade, both the scan head and the Controller must be sent
in to your local Nanosurf distributor for mounting the Video Camera on
the Scan Head and installing the Video Camera electronics in the Control-
ler. After the Controller has been returned, you should install the drivers for
the AFM Video Module (section Installing the drivers for the AFM Video
Module (p.25)).
Installing the Signal Module: S
- Connect the Break-out cable (Components, 17) to the Signal Out connec-
tor on the Controller (figure The easyScan 2 Controller).
In case of an upgrade, the Controller must be sent in to your local Nanosurf
distributor for mounting the Signal Module: S electronics in the Control-
ler.
Installing the Signal Module: A
- Connect one Signal Module cable (Components, 19) to the Signal Out
connector on the Controller and to the Output connector on the Signal
Module: A.
- Connect the other Signal Module cable to the Signal In connector on the
Controller and to the Input connector on the Signal Module: A.
In case of an upgrade, the Controller must be sent in to your local Nanosurf
distributor for mounting the Signal Module: A electronics in the Control-
ler.
Turning on the Controller
- Connect the easyScan 2 Controller (Components, 1) to the mains using
the mains cable (Components, 3) and turn it on.