Instruction Manual
Table of Contents Introduction……………………………………………………………………………………………..2 Camera Features………………………………………………………………………………………2 Getting started Install the memory card…………………………………………………………………….3 Install the battery……………………………………………………………………………..3 Battery charging………………………………………………………………………………..
Introduction This machine is designed as a sports camera. With 1080p high definition and 140 degree wide angle lens, it helps to capture beautiful scenery and record every moment of our lives. Just enjoy it and read this manual carefully before use.
Getting Started 1. Install the memory card: Follow the below illustration to insert a micro SD card into the camera. 4GB or above at higher speed class is required. Please format the card from the computer when using the camera at first time to avoid any reading failure.
3. Charging Two ways for battery charging <1> Use the USB cable to connect the camera and a computer. The screen of the camera will light up and show as below picture. Use up/down buttons to select “Charge”, and press OK button to confirm.
Basic Operation Video mode Press Mode button to enter into Video mode, and the video icon will show on the screen. Press Shutter button to start recording. The LED indicator light will flash while recording.
Video features: * Recycle(Loop recording) The icon “ “will show on the screen when it is turned on. Press the Shutter button, the camera will take a continuously recycling video and save each file by a specific time segment (1min/2mins/3mins/4mins/5mins/10mins/15mins).
Photo mode Press Mode button twice to enter into Photo mode, and the camera icon will show on the screen. Press Shutter button to take a picture.
Photo features: * White balance: There are Auto/Sunny/Cloudy/Tungsten/Fluorescent/ manual. When selecting Manual white balance mode, the screen will show manual white balance icon. Aim camera at white balance board and press Shutter button to set. To reset manual white balance again, turn the camera on and off to get the blinking icon.
Setup In any mode, press Menu button twice to enter into setup as below illustration. Use Up/Down buttons to browse and press OK button to confirm a setting. After selection, press Menu button again to return.
Computer System Requirement Windows 2000/XP : ●128 MB RAM, more than 125 MB free disk space. ●Available USB Interface. ●CD-‐ROM Driver. ●Recommended screen resolution 1024 × 768 pixels or higher. ●16-‐bit color or higher display adaptor. Windows Vista : ●800MHz processor and 512 MB of system memory.
Camera Specification Image sensor Lens 5.0MP 1/2.3" CMOS Sensor f=3.35mm ; F 2.4 / 140 degree wide angle Digital zoom Still Image mode: 1.0X ~ 4.0X Movie Clip Mode: 1.0X ~ 4.0X (except 1080P) Normal: 1/12 sec.
Underwater Housing The housing is 80 meters waterproof and 1 meter shockproof. When using in wet or underwater conditions, place the camera in the housing and close it properly to get good waterproof seal.
How to place the camera and remove the housing: Follow the below illustration to open the housing. 1. Pull out the lock latch. 2. Twist the lock cover according to the narrow sign (open). Follow the below illustration to place the camera in the housing.
Handling Notice before Use * Check carefully if there is any dust, hair, or substance on the O-‐ring. Clean it before placing the camera in the housing, or it may cause a leak. * Check the battery power and insert the memory card into the camera. Make sure the camera operation with the housing is normal.
DECLARATION OF CONFORMITY easypix herebly declares that the product GoXtreme Deep Sea is in conformity to all the essential requirements of Directive 1999/5/EC. The declaration of conformity can be downloaded here: http://www.easypix.info/download/pdf/doc_goxtreme_deepsea.pdf For technical help please visit our support area on www.easypix.eu.
