Operation Manual

Prior to Operating the Camera

Loading the Batteries and SD Memory Card

This camera uses 4 AA batteries or CR-V3 x 2. The batteries and SD card are located

in separate compartments. The battery compartment is located at the bottom of the

camera, while the SD card compartment is located at the back of the camera.

CAUTION!

1. Use only the specified battery or AC power adapter

(6.0V 2A) with this camera. Other power sources may

cause fire.

2.To improve battery performance, replace all

installed batteries at the same time and keep batter

way from heat.

3.To dispose off batteries, please refer to index of bat-

tery manufacturer.

4. Do not mix battery types or it may cause a fire or

explosion. Use only one battery type at one time

5. Batteries should be inserted in the battery compart-

ment with the "+" and "-" sides facing correctly.

6. For alternative power source, the optional AC

Adapter kit is available.

NOTE:

1. Upon loading new batteries, users will need to reset

their Basic Settings

2. Do not open the battery cover or remove the batteries

when the camera is in its ON status. Only remove the

batteries and SD card when the camera is not in use,

or in its OFF status.

3. If you do not plan on using the camera for a long period

of time, please remove the batteries and SD card.

1. Slide the battery cover in the

2. Load the batteries into the battery

compartment. (a)

3. Close the battery cover.

4. Flip the SD card compartment cover,

direction of the arrow, then lift to open.

(a)

(b)

SD Card Card

Battery Cover

and insert the SD card into the slot. (b)

5. Close the SD card cover.