Instructions

EN 20
Using the Clip and Bracket
The clip (2) and bracket (3) can be used to attach the camera (1) in various places.
Attaching to Clothing
The clip can be used to attach the camera to clothing.
1. Press the four arms of the clip into the two grooves (9) on the side of the camera
housing until they engage (Picture F).
2. Attach the clip to clothing (Picture G).
To detach it, push the camera out of the clip arms.
Placing on a Table
If the bracket is also used with the clip, the camera can be set up.
Clamp the clip to the smaller part of the bracket (Picture H). This can be moved on all
sides so that the camera can be aligned as you wish.
Affi xing to Smooth Surfaces
The clip, the bracket and the adhesive strip (3) that is also supplied are required. The
bracket can be affi xed to both horizontal and vertical surfaces.
1. Make sure that the surface to which the bracket is affi xed and the bottom of the brack-
et are free of any grease or dirt.
2. Peel one of the two protective fi lms off the adhesive strip and stick it onto the bottom
of the bracket (Picture I). Do not cover up the hole in the bracket!
3. Peel off the second protective fi lm from the adhesive strip, stick the bracket onto the
surface you want and press it on.
4. Clamp the clip to the smaller part of the bracket. This can be moved on all sides so
that the camera can be aligned as you wish (Picture J).
To fi x the position, use a screwdriver to tighten the screw of the bracket (Pic-
ture K).
Wall Mounting
The clip, the bracket and the screws and dowels that are supplied are required.
1. Make sure there are no cables in the wall at the drilling point.
2. Position the bracket against the place where it is to be attached and use a pen to
mark out 2 drill holes.
3. Choose a drill to match the dowel size and drill the holes at the markings.
4. Insert the dowels into the drill holes.
5. Screw the bracket securely in place.
6. Clamp the clip to the smaller part of the bracket. This can be moved on all sides so
that the camera can be aligned as you wish.
To fi x the position, use a screwdriver to tighten the screw of the bracket (Pic-
ture K).
04809_de-en-fr-nl_A5_V1.indb 2004809_de-en-fr-nl_A5_V1.indb 20 18.01.2019 14:14:3918.01.2019 14:14:39