User's Manual

- -14
© EASYGUARD Electronics. All right reserved.
-13-
© EASYGUARD Electronics. All right reserved.
Mount it where a thief cannot easily disconnect it, whether the hood is open or shut. Both the siren and its
wires should be difficult to find. This usually involves disguising the wire to look like a factory harness.
We do not recommend grounding the siren to its mounting screws. Instead, we recommend running both
the red and black wires into the passenger compartment and grounding to one common point for all
devices. Both wires are the same length and come already bonded together to make it easier. Whenever
possible, conceal your wires in the factory harnesses or in the same style loom as the factory.
When possible, place the siren on the same side of the vehicle as the control module, where its wires will
reach the control module’s wires without extending them. Always run the wires through the center of a
grommet, never through bare metal!
When installation the siren, please make sure which is downward for waterproof consideration
Note 18
Dome light supervision (optional)
If there is dome light wire and you want to use dome light supervision, please follow with below
instruction:
a.No need to connect the blue/black door trigger wire in 20 pin wire harness
b.Un-plug the 6 pin ignition wire harness to cut off power of the device first
c.Press down DIP switch 2 on alarm control module & wait for around 5 minutes
d.Re-plug 6 pin ignition wire harness to re-power of the device.
Then you should able to use dome light supervision function now.
Some things to remember about mounting the siren:
Keep it away from heat sources, such as radiators, exhaust manifolds, turbo-chargers, and heat shields.
Note 16
Window closer module wire connection with Ec002
If there is window closer module has a wire need to connect with EC002, please connect the white locking
wire in central door locking with the wire from the window closer module.
Note 17
Wiring method of horn or siren
The device default design is to connect with car factory horn with negative (-) 300mA output. If your vehicle
factory horn is negative output, you can connect it with the pink wire of the device EC002 directly.
Pink(-300mA)
1 2 3 4 5 6
Car original horn
Connect with negative power
wire of horn output
Connect with car OEM horn
If your horn is positive output or you are connect with an electrical siren like 6 tone or 1 tone siren, please use
a SPST relay to change the polarity first, here is the method:
Connect with horn or siren 12V+
Connect with pink wire of Ec002
Connect with fused 12V+
Note:You can also use a SPDT relay to have a GWR wire and wiring method is the same but no need to
connect 87a on SPDT relay.
There are 6 types engine start button available for optional as below:
The device default is equip with P1 style push start button, user can choose their preferred engine start
button style.
Engine Start Button Introduction