User's Manual

Installation for password keypad
P5: The touch password keypad mount position
P5: Inside of front windshield
How to mount the touch password keypad?
1.Tear off the sticker on the password keypad
2.Stick the touch password keypad on the left
bottom of inside of front windshield( the position
should be easily & convenient for you to input
the password)
3.Make sure there is no explosion proof film on
the area where you plan to mount the touch
password keypad
Before making your connections, plan how your wires will be routed through the vehicle. For instance, the
red 12V constant input and the remote start ignition wires will often be routed together to the ignition
switch harness. In order to keep the wiring neat and make it harder to find, you may wish to wrap these
wires together in electrical tape or conceal them in tubing similar to what the manufacturer used.
There are two acceptable ways of making a wire connection - solder connections and crimp connectors.
When properly performed, either type of connection is reliable and trouble-free. Regardless of whether
you solder your connections or you use mechanical type crimpon connections, ensure that all connections
are mechanically sound and that they are insulated.
Cheap electrical tape, especially when poorly applied, is not a reliable insulator. It often falls off in hot
weather. Use good-quality electrical tape or heat shrink.
Never twist-and-tape the wires together without soldering.
Never use “fuse taps”, as they can damage fuse box terminals.
-08-
© EASYGUARD Electronics. All right reserved.
-07-
© EASYGUARD Electronics. All right reserved.
P1: A pillar near the
cab in the car
P3
P5
P4
Important:
All the recommend mount position is for reference only and user can adjust the mount position to get a
maximum antenna working range
Try your best to keep all the antennas away from any metal product.
P5
P3
P4
P1
P2
P5: The touch password
keypad mount position
P5: Inside of front windshield
in the car
Once finish mount the PKE antenna, the front PKE
antenna and the rear PKE antenna looks like “T” shape
P3: The shorter PKE antenna mount position
P3: Inside of middle upper of the front
windshield in the car
P4: The 5M PKE antenna mount position
P4: Inside of the left upper of the rear
windshield in the car
P1 or P2: High frequency antenna mount position.
P1: A pillar near the cab in the car
P2: Under the steering wheel
User can choose to mount the high frequency antenna on PI or P2 position.
Back Face Tear off the sticker Password keypad
3
M 30
0
LSE
3M
3
00LS
E
3
M 3
00LS
E
3M
3
0
0
LSE
3M 3
00LS
E
3M
30
0
LSE
3
M
3
00LS
E
3M
3
0
0
LS
E
3
M 3
00
LS
E
3M
3
0
0LSE
7
8 9
0C
3
M
30
0
LS
E
3M
3
0
0LS
E
3
M
3
0
0
LS
E
3
M
30
0
LS
E
3
M 3
00
LS
E
3
M
3
0
0
LS
E
3
M 3
0
0LS
E
7
8 9
0C
1
2 3
LED1 LED2
4
5 6
NOTE:
If you do not want to use touch password
keypad entry function, no need to
install/mount the touch password keypad.
Making Your Wiring Connections