User's Manual

Method 2:
Use a screw driver and push it into the hole of the
ignition cylinder (see photo on the left), turn the
ignition key to ACC position, then pull out the key
with force will take out the ignition cylinder.Then
remove wires from ignition switch and put the push
start button over the empty key cylinder slot.
Important:
Only a qualified staff can do this as there is risk
to lock the steering lock again if the operation is
not correct. If you are not a qualified staff, we
recommend you to use the method 1 to release
the steering lock.
push here
then pull out
the cylinder
3.Stick the chip immobilizer on the induction of car
coil, make sure the induction of chip and coil is
good.
Chip
Foam or other materials
Induction coil of original car
Coin or other metal pad
2.Put the car original remote control(include the chip
immobilizer) into the coil, make sure the induction of the
chip immobilizer and the coil is good.
Installation for chip immobilizer
If there is chip immobilizer in original key fobs, please follow below method
Method 1:
1.Take out the original induction coil from the ignition lock.
Car original
induction coil
Method 2:
1.Take out the chip immobilizer from the car OEM
remote control.
2.Take out the original induction coil from the
ignition lock.
Car original
induction coil
Reminder: Some chips are with weak signal and is hard to start the car when put on the car original coil.
Then need to add a coin or other metal pad underneath the chip to enlarge the signal of it (see above drawing)
Method 3:
Use an extra bypass module to bypass it, installation steps as below:
2.Taping induction wires 2-3 circles on
the ignition lock header
Important:
remote control and induction wire well
around the ignition lock header to make
sure that the car can be started.
Please fix the car OEM
Programming method:
Important:
When you do the programming, please remember to keep pressing the programming switch on the control
module all the time till you finish the programming on both remote controls. Once the vehicle is enter
programming status, need to finish both key fobs programming in 10 seconds.
The alarm can program 2 key fobs maximum.
The key fob is programmed with the control module already before out of the factory and no need to program
them again.
Programming
switch
1.Put the whole remote control (please remember to take out battery from remote if you do so) include the chip
immobilizer into the bypass module.
Note: if size of remote control is big, user can put PCB or chip inside the bypass module.
Bypass
module
Car OEM
remote control
must fix well
in induction
coil
Induction wire taping
on the ignition lock
Fix the
induction
wire well on
the ignition
lock with
electrical tape
Induction coil
1.In disarm status, keep pressing the programming switch on the control
module (refer to programming switch) till turn signal light keep lighting
on, this means the alarm is entering into programming status. At this
time, take the 1st remote control close to the control module & keep
pressing lock button on the first remote control, the turn signal light flash
once, this means the first remote control is finished programming.
2.Take the 2nd remote control close to the control module & keep
pressing lock button on the 2nd remote control, turn signal light flash
twice, this means the 2nd remote control is successfully code learned.
After that, release the pressing on the programming switch and the
programming is finished.
User can use this method to add new key fob on the device.
-22-
© EASYGUARD Electronics. All right reserved.
-21-
© EASYGUARD Electronics. All right reserved.