Operation Manual

3. SET VIEW / FUNCTION ELEMENTS

1. Function switch

Position Information

OFF Device is switched off

PROG Entering of calling numbers, calling number sequence, PIN-Code and further parameters

ON Device is in supervision mode

2. Selection switch

EasyAlarm

monitors depending on the position of the selection switch

Position Monitoring functions (Function switch on position ON)

I Wired sensor-1 enabled. Acoustical monitoring disabled!

II Wired sensor-1 enabled. Acoustical monitoring disabled!

III Wired sensor-1 enabled. Acoustical monitoring enabled with highest sensitivity => Alarm is triggered if

noise level is exceeded two or three times within a short period

Note: Monitoring functions can be modified individually according to section 5.4ff!

3. Keypad

When function switch is on position PROG, you can enter the calling numbers or do further programming. If function

switch is on position ON pressing any key will start a test call.

Keys are marked with 1 2 3 4 5 6 7 8 9 * 0 # .in the following sections.

4. Loudspeaker

The integrated loudspeaker is used for voice guidance during the programming as well as for hands-free communication

during phone connection.

5. Microphone

Is used during hands-free connection and for recording of individual message.

6. LED

Status of LED Operation mode

Green Waiting period

Green brief flashing every 4 seconds, also if acoustical

monitoring is active by exceed set noise level

Supervision mode activated

Green is on and off for 4 seconds alternatively Supervision mode deactivated

Orange Phone connection

7. Battery compartment

The 9V-battery is used as a backup during power failure.

 Please note: The telephone cord must be disconnected before opening the battery

compartment because otherwise you can get in contact with the telecommunication voltage!

8. Telephone jack (-LINE)

The plug must be locked in the jack. To disconnect press pawl.

9. External ports (EXT/≂) for accessories (as motion sensor) and power supply.

-LINE



EXT/