Operation Manual

26
10.7 Dialling-in (Remote-access)
10.7.1 Program ringing cycles
The number of ringing cycles until EasyAlarm® answers the call is defined in register 4 7 :
OFF ON
PROG
*. 9. 7. 1. 3 4 7 #. #. *. Value #.
OFF ON
PROG
Value Comment
0
EasyAlarm® does not answer any call
2..9
EasyAlarm® answers call after Value ringing cycles (factory setting: Value=2)
10.7.2 Dialling in sequence
Behaviour on dialling-in mode is defined in register 7 0 that can be read out or modified as follows:
OFF ON
PROG
*. 9. 7. 1. 3 7 0 #. #. *. Value #.
OFF ON
PROG
Value Comment
0
EasyAlarm® answers call directly after the programmed ringing cycles (=factory setting)
1
EasyAlarm® answers call after a two-step dialling -in sequence
10.7.3 Connection mode after dialling-in
Phone connection mode after dialling-in is defined in register 7 1 that can be read out or modified as follows:
OFF ON
PROG
*. 9. 7. 1. 3 7 1 #. #. *. Value #.
OFF ON
PROG
Value Comment
0
EasyAlarm
®
does not signal a successful dialling in and switches in listening-in connection (=factory setting)
1
EasyAlarm
®
establishes hands-free connection announced by three gong signals.
10.7.4 Handling of incoming calls
Answering incoming call by pressing the emergency button or any key can be selected as follows:
OFF ON
PROG
*. 9. 7. 1. 3 7 2 #. #. *. Value #.
OFF ON
PROG
Value Comment
0
EasyAlarm
®
is not responding by activation of the emergency button or any key of the alarm unit
1 The call can be received by pressing the emergency button or any key of the alarm unit (=factory setting)
10.8 Remote programming
The calling numbers as well as the sequence of the calling numbers are programmable during phone connection. This
function is disabled (factory setting), but can be enabled as follows:
10.8.1 Enabling of remote programming
Remote programming is defined in register 7 6 that can be read out or modified as follows:
OFF ON
PROG
*. 9. 7. 1. 3 7 6 #. #. *. Value #.
OFF ON
PROG
Value Comment
0
EasyAlarm® cannot be remote programmed (=factory setting)
1
EasyAlarm® is ready for remote programming
Value
Value
Value
Value
Value